Cisco CCNA考试七十九题

来源：作者：出处：巧巧读书 2006-07-25 进入讨论组

76. How do switches use store and forward?

A. The switch waits only for the header to be received

before it checks the destination address and starts

forwarding the packets
B. The LAN switch copies the entire frame into

its buffers and then looks up the destination address

in its forwarding, table and determines

the outgoing interface
C. By using a class II repeater in a collision domain
D. By using broadcast addresses as source addresses

Packet-switching technique in which frames are completely processed

before being forwarded out the appropriate port.

This processing includes calculating the CRC and checking the destination address.

In addition, frames must be temporarily stored until network resources

(such as an unused link) are available to forward the message. Contrast

with cut-through packet switching.

77. Choose all of the following that are needed to support full-duplex Ethernet.

A. Multiple paths between multiple stations on a link
B. Full-duplex NIC cards
C. Loop back and collision detection disabled
D. Automatic detection of full-duplex operation by all connected stations

Capability for simultaneous data transmission between a sending station

and a receiving station.

78. What two types of technology does 100BaseT use?

A. Switching with 53-byte cells
B. CSMA/CD
C. IEEE 802.5
D. 802.3u

100-Mbps baseband Fast Ethernet specification using UTP wiring.

Like the 10BaseT technology on which it is based, 100BaseT sends link

pulses over the network segment when no traffic is present. However,

these link pulses contain more information than those used in 10BaseT.

Based on the IEEE 802.3 standard.

79. Choose all of the following that are advantages

to segmenting with routers.

A. Manageability
B. Flow control
C. Explicit packet lifetime control
D. Multiple active paths

All of the above is correct.

A router is a Network layer device that uses one or more metrics

to determine the optimal path along which network traffic should be forwarded.

Routers forward packets from one network to another based on network layer information

文章地址： http://www.qqread.com/net-knowledge/p950173081.html